Home › SUSPENSION & AXLE › SUSPENSION › REAR SHOCK ABSORBER

REAR SHOCK ABSORBER > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY LH
  1. Temporarily install the bracket to the shock absorber lower side with the bolt and nut.

    NOTICE:
    Fix the nut in place and temporarily install the bolt.



    C127561
  1. Temporarily install the shock absorber upper side to the suspension member with the bolt and nut.

    NOTICE:
    Fix the nut in place and temporarily install the bolt.



    C129929
  1. Install the shock absorber with the 2 bolts to the axle carrier.

    Torque:
    80 N*m{ 816 kgf*cm , 59 ft.*lbf }



2. INSTALL REAR WHEEL

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }



3. STABILIZE SUSPENSION
  1. Lower the vehicle.

  1. Press down on the vehicle several times to stabilize the suspension.



4. TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH
  1. For the shock absorber upper and lower side, fix the 2 nuts in place and tighten the 2 bolts.

    Torque:
    80 N*m{ 816 kgf*cm , 59 ft.*lbf }



5. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
  1. Inspect and adjust the rear wheel alignment (Click here).