REAR STABILIZER BAR > INSTALLATION |
| 1. INSTALL REAR STABILIZER BUSH |
![]() |
Install the 2 bushes.
| 2. INSTALL REAR STABILIZER BAR |
Install the stabilizer bar to the vehicle.
| 3. INSTALL REAR NO. 1 STABILIZER BAR BRACKET |
![]() |
Install the 2 brackets with the 4 nuts.
| 4. INSTALL REAR COIL SPRING INSULATOR LOWER LH |
Install the insulator lower to the suspension No. 2 arm.
| 5. INSTALL REAR COIL SPRING LH |
Install the coil spring to the suspension No. 2 arm.
| 6. INSTALL REAR COIL SPRING INSULATOR UPPER LH |
Align the stopper part of the insulator upper with the coil spring tip, and install the insulator upper.
| 7. INSTALL REAR COIL SPRING INSULATOR LOWER RH |
| 8. INSTALL REAR COIL SPRING RH |
| 9. INSTALL REAR COIL SPRING INSULATOR UPPER RH |
| 10. TEMPORARILY INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY LH |
![]() |
Temporarily install the No. 2 suspension arm to the suspension member with the bolt and nut.
| 11. TEMPORARILY INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY RH |
| 12. INSTALL REAR STABILIZER LINK ASSEMBLY LH |
![]() |
Install the stabilizer link with the 2 nuts.
| 13. INSTALL REAR STABILIZER LINK ASSEMBLY RH |
| 14. INSTALL SKID CONTROL SENSOR WIRE (for 2WD) |
![]() |
Connect the skid control sensor wire connector (labeled A) to the skid control sensor.
Install the sensor clamp (labeled B) with the bolt (labeled C).
![]() |
Install the sensor clamps (labeled D) with the 2 nuts (labeled E).
Install the sensor clamp (labeled F) with the bolt (labeled G).
![]() |
Insert the connector and grommet into the inside of the vehicle through the passage hole in the wheel house.
![]() |
Hold the grommet and pull it toward the outside of the vehicle. Then fix the grommet in place so that it is not tilted.
![]() |
Connect the skid control sensor wire connector.
| 15. INSTALL REAR SPEED SENSOR LH (for 4WD) |
![]() |
Install the sensor (labeled A) with the bolt (labeled B).
Install the sensor clamp (labeled C) with the nut (labeled D).
![]() |
Install the sensor clamps (labeled E) with the 2 nuts (labeled F).
Install the sensor clamp (labeled G) with the bolt (labeled H).
![]() |
Insert the connector and grommet to the inside of the vehicle through the passage hole in the wheel house.
![]() |
Hold the grommet and pull it from the inside of the vehicle to the outside of the vehicle. Then fix it in place so that it is not tilted.
![]() |
Connect the speed sensor connector.
| 16. INSTALL REAR SPEED SENSOR RH (for 4WD) |
| 17. INSTALL REAR WHEEL |
| 18. STABILIZE SUSPENSION |
Lower the vehicle.
Press down on the vehicle several times to stabilize the suspension.
| 19. TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY LH |
Install the nut and 2 bolts.
| 20. TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY RH |
| 21. INSPECT AND ADJUST REAR WHEEL ALIGNMENT |
Inspect and adjust the rear wheel alignment (Click here).
| 22. CHECK SPEED SENSOR SIGNAL |
w/o VSC:
Check the speed sensor signal (Click here).
w/ VSC:
Check the speed sensor signal (Click here).