Home › SUSPENSION & AXLE › SUSPENSION › REAR STABILIZER BAR

REAR STABILIZER BAR > REMOVAL

for Preparation Click here



1. REMOVE REAR WHEEL


2. REMOVE REAR STABILIZER LINK ASSEMBLY LH


    C127558
  1. Remove the nut and disconnect the link from the suspension No. 2 arm.

  1. Remove the nut and link from the stabilizer bar.



3. REMOVE REAR STABILIZER LINK ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.



4. REMOVE REAR NO. 2 SUSPENSION ARM ASSEMBLY LH


C129667
  1. Remove the bolt, nut and suspension arm from the suspension member.



5. REMOVE REAR NO. 2 SUSPENSION ARM ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.



6. REMOVE REAR COIL SPRING INSULATOR UPPER LH
  1. Remove the insulator upper from the coil spring.



7. REMOVE REAR COIL SPRING LH
  1. Remove the coil spring from the suspension No. 2 arm.



8. REMOVE REAR COIL SPRING INSULATOR LOWER LH
  1. Remove the insulator lower from the suspension No. 2 arm.



9. REMOVE REAR COIL SPRING INSULATOR UPPER RH

HINT:
Use the same procedures described for the LH side.



10. REMOVE REAR COIL SPRING RH

HINT:
Use the same procedures described for the LH side.



11. REMOVE REAR COIL SPRING INSULATOR LOWER RH

HINT:
Use the same procedures described for the LH side.



12. REMOVE REAR NO. 1 STABILIZER BAR BRACKET


    C127568
  1. Remove the 2 nuts and bracket.

    HINT:
    Use the same procedures for the other side.



13. REMOVE REAR STABILIZER BAR
  1. Remove the stabilizer bar from the vehicle.

    NOTICE:
    When removing the stabilizer bar from the vehicle, make sure not to damage the sensor wire, brake hose, etc.



14. REMOVE REAR STABILIZER BUSH
  1. Remove the 2 stabilizer bushes from the stabilizer bar.