REAR TRAILING ARM > INSTALLATION |
| 1. TEMPORARILY TIGHTEN REAR TRAILING ARM ASSEMBLY LH |
![]() |
Temporarily install the trailing arm with the 3 bolts and nut to the axle carrier and suspension arm bracket.
| 2. INSTALL NO. 2 PARKING BRAKE CABLE ASSEMBLY |
Connect the cable to the backing plate and parking brake shoe lever.
Pass the cable through the backing plate, and then connect the cable to the lever.
Install the cable to the backing plate with the bolt.

Install the clamp and clamp bolt (labeled F) to the trailing arm.
Install the clamp and clamp bolt (labeled E) to the rear suspension crossmember.
Install the clamp and clamp bolt (labeled D) to the crossmember.
Install the clamp and clamp bolt (labeled C) to the body.
Install the casing cap and casing cap bolt (labeled B) to the body.
Install the cable clamp (labeled A) to the body.
| 3. INSTALL REAR WHEEL |
| 4. TIGHTEN REAR TRAILING ARM ASSEMBLY LH |
Tighten the 3 bolts and nut.
| 5. INSPECT AND ADJUST REAR WHEEL ALIGNMENT |
Inspect and adjust the rear wheel alignment (Click here).