Home › BODY ELECTRICAL › WIPER AND WASHER › WIPER ECU (w/ Rain Sensor)

WIPER ECU (w/ Rain Sensor) > INSTALLATION

for Preparation Click here



1. INSTALL WINDSHIELD WIPER RELAY ASSEMBLY (for RHD)


B133492
  1. Install the wiper relay with the bolt.

  1. Connect the connector.



2. INSTALL WINDSHIELD WIPER RELAY ASSEMBLY (for LHD)


B133491
  1. Install the wiper relay with the bolt.

  1. Connect the connector.



3. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY (w/ Knee Airbag) (for RHD)


B127987
  1. Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Install the driver side knee airbag with the 4 bolts.

    Torque:
    10 N*m{ 101 kgf*cm , 7 ft.*lbf }



4. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag) (for RHD)


B132919
  1. Attach the 8 claws to install the lower instrument panel finish panel.

  1. Install the 2 screws.



5. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)


    B129996
  1. Attach 3 claws to install the instrument panel under cover.

  1. Install the 2 screws.



6. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY (for LHD)


    B129887
  1. Attach the 2 hinges to install the door.



    B129889E03
  1. Attach the claw to the glove compartment door stopper.

  1. While pushing in the sides of the glove compartment door in the direction indicated by the arrows in the illustration, close the door to engage it to the 2 stoppers.



7. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)


B129997
  1. Attach the 3 claws to install the instrument panel under cover.



8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL