Home › BODY ELECTRICAL › OTHER SYSTEM › REAR POWER OUTLET SOCKET (for Long Body)

REAR POWER OUTLET SOCKET (for Long Body) > INSTALLATION



1. INSTALL REAR POWER OUTLET SOCKET ASSEMBLY


B133576
  1. Attach the 2 claw fittings to install the socket.



2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH


    B129706
  1. Install the belt hanger to the trim board.

  1. Connect the power outlet socket connector.

  1. Attach the 4 clips and 5 claws to install the trim board.

  1. Install the 2 screws and 2 bolts.



    B137546
  1. Connect the rear No.1 seat belt's floor anchor.

    1. Connect the floor anchor with the bolt.

      Torque:
      42 N*m{ 428 kgf*cm , 31 ft.*lbf }

    2. Install the anchor cover.



3. INSTALL TETHER ANCHOR BRACKET SUB-ASSEMBLY


4. INSTALL RECLINING REMOTE CONTROL LEVER BEZEL LH


5. INSTALL REAR FLOOR FINISH PLATE


    B129704
  1. Attach the 2 claws and 6 clips to install the finish plate.



6. INSTALL BACK DOOR WEATHERSTRIP


7. INSTALL REAR FLOOR NO. 1 MAT SUPPORT SIDE PLATE


B129705
  1. Attach the 7 clips to install the side plate.

  1. Install the 4 screws.



8. INSTALL REAR FLOOR NO. 2 BOARD


9. INSTALL REAR FLOOR NO. 3 BOARD


10. INSTALL DECK BOARD ASSEMBLY


11. INSTALL REAR FLOOR NO. 1 BOARD


12. INSTALL TONNEAU COVER ASSEMBLY


13. INSTALL PACKAGE TRAY TRIM POCKET SUB-ASSEMBLY


14. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH


15. INSTALL REAR DOOR SCUFF PLATE LH


    B129703
  1. Attach the 9 claws and 2 clips to install the scuff plate.



16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL