REAR POWER OUTLET SOCKET (for Short Body) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE REAR DOOR SCUFF PLATE LH |
![]() |
Using a screwdriver, detach the 8 claws and remove the scuff plate.
| 3. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH |
| 4. REMOVE PACKAGE TRAY TRIM POCKET SUB-ASSEMBLY |
| 5. REMOVE TONNEAU COVER ASSEMBLY |
| 6. REMOVE REAR FLOOR NO. 1 BOARD |
| 7. REMOVE DECK BOARD ASSEMBLY |
| 8. REMOVE REAR FLOOR NO. 3 BOARD |
| 9. REMOVE REAR FLOOR NO. 2 BOARD |
| 10. REMOVE JACK CARRIER ASSEMBLY |
![]() |
Using a clip remover, remove the 7 clips and remove the jack carrier.
| 11. REMOVE REAR FLOOR NO. 1 MAT SUPPORT SIDE PLATE |
![]() |
Remove the 4 screws.
Using a clip remover, detach the 7 clips and remove the plate.
| 12. REMOVE BACK DOOR WEATHERSTRIP |
| 13. REMOVE REAR FLOOR FINISH PLATE |
![]() |
Using a clip remover, detach the 6 clips and remove the finish plate.
| 14. REMOVE RECLINING REMOTE CONTROL LEVER BEZEL LH |
| 15. REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR COVER |
![]() |
Using a screwdriver, detach the 4 claws and remove the cover.
| 16. REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR BRACKET |
![]() |
Remove the bolt, 2 washers, collar and bracket.
| 17. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH |
![]() |
Disconnect the rear No. 1 seat belt's floor anchor.
Remove the anchor cover.
Remove the bolt and disconnect the floor anchor.
![]() |
Remove the bolt and 2 screws.
Using a screwdriver, detach the 5 claws.
Using a clip remover, detach the 5 clips and remove the trim board.
Disconnect the power outlet socket connector.
Remove the belt hanger.
| 18. REMOVE REAR POWER OUTLET SOCKET ASSEMBLY |
![]() |
Detach the 2 claws fittings and remove the socket.