POWER WINDOW CONTROL SYSTEM > DATA LIST / ACTIVE TEST |
| READ DATA LIST |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Read the Data List.
| Item | Measurement Item / Display (Range) | Normal Condition | Diagnosis Note |
| D P/W Auto Switch | Driver side power window auto UP / DOWN switch signal / ON or OFF | ON: Driver side power window AUTO switch operates OFF: Driver side power window AUTO switch does not operate | - |
| D P/W Up Switch | Driver side power window manual UP switch signal / ON or OFF | ON: Driver side power window UP switch operates OFF: Driver side power window UP switch does not operate | - |
| D P/W Down Switch | Driver side power window manual DOWN switch signal / ON or OFF | ON: Driver side power window DOWN switch operates OFF: Driver side power window DOWN switch does not operate | - |
| Glass Pos Info | Glass position signal min.: 128 hex max.: approx. 390 hex (front side) max.: approx. 354 hex (rear side) | Closed: 128 hex Open: approx. 390 hex (front side) Open: approx. 354 hex (rear side) | - |
| Glass Pos - 1/4 | Margin for jam protection triggering force of window glass within range of fully closed to 1/4 open position / OK or CAUTION | OK: Margin is sufficient during manual UP operation CAUTION: May be displayed even when no resistance is applied in each position. In this case, there is a foreign object stuck in that position. | - |
| Glass Pos - 2/4 | Margin for jam protection triggering force of window glass within range of 1/4 to 1/2 open position / OK or CAUTION | OK: Margin is sufficient during manual UP operation CAUTION: May be displayed even when no resistance is applied in each position. In this case, there is a foreign object stuck in that position. | - |
| Glass Pos - 3/4 | Margin for jam protection triggering force of window glass within range of 1/2 to 3/4 open position / OK or CAUTION | OK: Margin is sufficient during manual UP operation CAUTION: May be displayed even when no resistance is applied in each position. In this case, there is a foreign object stuck in that position. | - |
| Glass Pos - Open | Margin for jam protection triggering force of window glass within range of 3/4 to fully open position / OK or CAUTION | OK: Margin is sufficient during manual UP operation CAUTION: May be displayed even when no resistance is applied in each position. In this case, there is a foreign object stuck in that position. | - |
| Item | Measurement Item / Display (Range) | Normal Condition | Diagnosis Note |
| D P/W Auto Switch | Driver side power window auto UP / DOWN switch signal / ON or OFF | ON: Driver side power window AUTO switch operates OFF: Driver side power window AUTO switch does not operate | - |
| Item | Measurement Item / Display (Range) | Normal Condition | Diagnosis Note |
| Communication D-Door Motor | Connection status between power window regulator motor assembly (driver door) and main body ECU / OK or STOP | OK: Connection Stop: No connection | - |
| D Door Courtesy Switch | Driver side door courtesy switch signal / ON or OFF | ON: Driver door open OFF: Driver door closed | - |
| P Door Courtesy Switch | Front passenger side door courtesy switch signal / ON or OFF | ON: Front passenger door open OFF: Front passenger door close | - |
| PERFORM ACTIVE TEST |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Performing the Active Test by following the prompts on the tester screen.
| Item | Test Details | Diagnostic Note |
| Power window | OFF / UP / DOWN (OFF) | - |
| Item | Test Details | Diagnostic Note |
| IG OFF P/W | ON / OFF | - |