FRONT LOWER BALL JOINT > INSTALLATION |
| 1. INSTALL FRONT LOWER BALL JOINT ASSEMBLY |
Install the front lower ball joint assembly with the nut to the steering knuckle.
Install a new clip.
| 2. INSTALL STEERING KNUCKLE WITH AXLE HUB |
Align the shaft splines and drive in the drive shaft.
Install the steering knuckle with axle hub with the 2 bolts and 2 nuts.
| 3. CONNECT FRONT SUSPENSION LOWER NO. 1 ARM SUB-ASSEMBLY |
Connect the lower arm with the 2 bolts and nut to the ball joint.
| 4. CONNECT TIE ROD END SUB-ASSEMBLY |
![]() |
Connect the tie rod end onto the steering knuckle with the castle nut.
Install a new cotter pin.
| 5. INSTALL FRONT DISC |
![]() |
Align the matchmarks and install the disc.
| 6. INSTALL FRONT DISC BRAKE CYLINDER ASSEMBLY |
![]() |
Install the cylinder with the 2 bolts.
| 7. INSTALL FRONT AXLE HUB NUT |
Align the shaft splines and drive in the drive shaft.
Install the steering knuckle with axle hub with the 2 bolts and 2 nuts.
| 8. INSTALL FRONT SPEED SENSOR |
![]() |
Set the sensor body into the knuckle, and then install the sensor with the bolt.
Install the sensor clamp and sensor clip as follows.

Simultaneously perform the following: 1) hang the hook part of the sensor clamp (labeled A) on the part of the flexible hose bracket (labeled C); and 2) insert the hook part of the sensor clamp (labeled B) to the part of the flexible hose bracket (labeled D).
Install the sensor clamp to the flexible hose clamp and flexible hose bracket with the bolt (labeled E).
Insert the sensor clip (labeled F) into the hole on the absorber lower bracket.
![]() |
Install the sensor clamp and sensor clip as follows.
Set the sensor clamp (labeled G) on the side member, and then install the bolt (labeled H).
Insert the sensor clip (labeled I) into the hole on the apron.
![]() |
Connect the sensor connector.
| 9. INSTALL FRONT WHEEL |
| 10. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT |
Inspect and adjust the front wheel alignment (Click here).