Home › SUSPENSION & AXLE › SUSPENSION › FRONT LOWER BALL JOINT

FRONT LOWER BALL JOINT > INSPECTION

for Preparation Click here



1. INSPECT FRONT LOWER BALL JOINT ASSEMBLY LH


C132059
  1. As shown in the illustration, move the ball joint stud back and forth 5 times before installing the nut.

  1. Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the fifth turn.

    Standard turning torque:
    0.98 to 3.43 N*m (10 to 35 kgf*cm, 9 to 30 in.*lbf) or less

  1. Check for any cracks and grease leaks on the ball joint dust cover.