FRONT LOWER BALL JOINT > REMOVAL |
| 1. REMOVE FRONT WHEEL |
| 2. REMOVE FRONT SPEED SENSOR |
![]() |
Disconnect the sensor connector.
![]() |
Remove the sensor clip (labeled A), bolt (labeled B) and sensor clamp (labeled C).
Remove the sensor clip (labeled D), bolt (labeled E) and sensor clamp (labeled F).

![]() |
Remove the bolt and sensor body from the knuckle.
| 3. REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY |
![]() |
Remove the 2 bolts and cylinder.
| 4. REMOVE FRONT DISC |
![]() |
Put matchmarks on the disc and axle hub.
Remove the disc.
| 5. REMOVE FRONT AXLE HUB NUT |
![]() |
Using SST and a hammer, unstake the staked part of the nut.
While applying the brakes, remove the lock axle hub nut.
| 6. DISCONNECT FRONT SUSPENSION LOWER NO. 1 ARM SUB-ASSEMBLY |
![]() |
Remove the 2 nuts and bolt, and disconnect the lower arm from the ball joint.
| 7. DISCONNECT TIE ROD END SUB-ASSEMBLY |
Remove the cotter pin and castle nut.
![]() |
Using SST, disconnect the tie rod end from the steering knuckle.
| 8. REMOVE STEERING KNUCKLE WITH AXLE HUB |
![]() |
Remove the 2 bolts and 2 nuts, and disconnect the shock absorber from the steering knuckle.
![]() |
Put matchmarks on the drive shaft and the axle hub.
Using a plastic-faced hammer, remove the steering knuckle with axle hub.
| 9. REMOVE FRONT LOWER BALL JOINT ASSEMBLY |
![]() |
Remove the clip and nut.
Using SST, remove the front lower ball joint assembly.