Home › TRANSMISSION ยท U660F AUTOMATIC TRANSAXLE › SHIFT LEVER

SHIFT LEVER > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT SHIFT LEVER POSITION
  1. When moving the shift lever from P to R with the ignition switch ON and the brake pedal depressed, make sure that it moves smoothly and correctly into position.

  1. Check that the shift lever does not stop when moving the shift lever from R to P, and check that the shift lever does not stick when moving the shift lever from D to M.

  1. Start the engine and make sure that the vehicle moves forward after moving the shift lever from N to D and moves in reverse after moving the shift lever to R.
    If the operation cannot be performed as specified, inspect the park/neutral position switch assembly and check the floor shift assembly installation condition.



2. CHECK SHIFT LOCK OPERATION
  1. Move the shift lever to P.

  1. Turn the ignition switch off.

  1. Check that the shift lever cannot be moved from P.

  1. Turn the ignition switch to ON, depress the brake pedal and check that the shift lever can be moved to other positions.
    If the operation cannot be performed as specified, inspect the floor shift assembly and shift lock control unit.



3. CHECK SHIFT LOCK RELEASE BUTTON OPERATION
  1. When operating the shift lever with the shift lock release button pressed, check that the lever can be moved to any position.
    If the operation cannot be performed as specified, check the floor shift assembly.



4. CHECK KEY INTERLOCK OPERATION
  1. Turn the ignition switch to ON.

  1. Depress the brake pedal and move the shift lever to any position other than P.

  1. Check that the ignition switch cannot be turned off.

  1. Move the shift lever to P, turn the ignition switch off and check that the key can be removed.
    If the results are not as specified, inspect the shift lock control ECU.