Home › BODY ELECTRICAL › LIGHTING › LUGGAGE ROOM LIGHT

LUGGAGE ROOM LIGHT > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
w/ Navigation System for HDD:
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE BACK DOOR CENTER GARNISH


    B129944
  1. Using a screwdriver, detach the 4 claws and 4 clips and remove the garnish.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE BACK DOOR SIDE GARNISH LH


    B129945
  1. Using a screwdriver, detach the 2 claws and 2 clips and remove the garnish.



4. REMOVE BACK DOOR SIDE GARNISH RH

HINT:
Use the same procedure described for the LH side.



5. REMOVE BACK DOOR TRIM BOARD


    B129943
  1. Using a screwdriver, detach the 13 clips and remove the trim board.

    HINT:
    1. Tape the screwdriver tip before use.
    2. If the screwdriver cannot reach the clips, pull on the lower trim to remove it.

  1. Remove the 5 screws and the back door trim pocket.



6. REMOVE BACK DOOR COURTESY LIGHT ASSEMBLY


    B135643
  1. Using a screwdriver, pry out the light as shown in the illustration.

    HINT:
    Tape the screwdriver tip before use.



    B135645
  1. Detach the 4 claws and remove the light shade.



    B135646
  1. Remove the light bulb from the light.