REAR FOG LIGHT ASSEMBLY > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE REAR BUMPER COVER (for Bumper Attached Type) |
![]() |
Put protective tape around the bumper cover.
Fully open the back door.
![]() |
w/ Rear Fender Mudguard:
Remove the 3 screws and 7 clips.
![]() |
w/o Rear Fender Mudguard:
Remove the 7 screws and 7 clips.
![]() |
Pull the rear bumper cover to detach the 12 claws.
![]() |
Open the back door one notch and following the order in the illustration, pull down the left side of the cover, then pull down the right side of the cover and remove it by pulling it out from between the back door and body.
Disconnect the rear fog light connector.
w/ Licence Plate Light:
Disconnect the licence plate light connector.
| 3. REMOVE REAR FOG LIGHT ASSEMBLY LH (for Bumper Attached Type) |
![]() |
Remove the 3 bolts and rear fog light.
| 4. REMOVE REAR FOG LIGHT ASSEMBLY (for Back Door Attached Type) |
![]() |
Remove the 2 screws and rear fog light.
Disconnect the connector.