DTC B2281 "P" Signal Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| B2281 | Communication or the communication line between the main body ECU and shift lock control ECU is abnormal. |
|

| 1.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - SHIFT LOCK CONTROL ECU) |
![]() |
Disconnect the E18 main body ECU connector.
Disconnect the E44 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E18-15 (P) - E44-7 (P2) | Always | Below 1 Ω |
| E18-15 (P) or E44-7 (P2) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.CHECK SHIFT LOCK CONTROL ECU |
Temporarily replace the shift lock control ECU with a new or normally functioning one.
Check that the engine starts normally.
|
| ||||
| OK | ||
| ||