Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT DIMMER RELAY

HEADLIGHT DIMMER RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT HEADLIGHT DIMMER RELAY


B112776
  1. Remove the headlight dimmer relay from the engine room No. 2 relay block.

  1. Measure the resistance of the relay.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    3 - 5
    Below 1 Ω
    (Battery voltage applied to terminals 1 and 2)

    If the result is not as specified, replace the relay.