Home › BODY ELECTRICAL › LIGHTING › BRK RELAY (w/ VSC)

BRK RELAY (w/ VSC) > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT BRK RELAY


A087121E09
  1. Remove the BRK relay from the engine room No. 1 relay block.

  1. Measure the resistance of the relay.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 4
    Below 1 Ω
    3 - 4
    10 kΩ or higher
    (Battery voltage applied to terminals 1 and 2)
    3 - 5
    10 kΩ or higher
    3 - 5
    Below 1 Ω
    (Battery voltage applied to terminals 1 and 2)

    If the result is not as specified, replace the relay.