Home › TRANSMISSION ยท U660F AUTOMATIC TRANSAXLE › OIL PUMP

OIL PUMP > INSPECTION

for Preparation Click here



1. INSPECT FRONT OIL PUMP BODY AND GEAR SUB-ASSEMBLY


C138512
  1. Turn the drive gear with 2 screwdrivers and make sure that it rotates smoothly.

    NOTICE:
    Be careful not to damage the lip of the oil seal.



2. INSPECT CLEARANCE OF FRONT OIL PUMP BODY AND GEAR SUB-ASSEMBLY


C138509
  1. Push the driven gear to one side of the oil pump body.

  1. Using a feeler gauge, measure the clearance.

    Standard clearance:
    0.08 to 0.15 mm (0.00315 to 0.00590 in.)

    Maximum clearance:
    0.15 mm (0.00590 in.)

    If the clearance is more than the maximum, replace the front oil pump body and gear sub-assembly.



    C138511
  1. Using a straightedge and feeler gauge, measure the side clearance of both gears.

    Standard side clearance:
    0.025 to 0.04 mm (0.000984 to 0.00157 in.)
    Maximum side clearance:
    0.04 mm (0.00157 in.)

    If the clearance is more than the maximum, replace the front oil pump body and gear sub-assembly.
    Drive Gear Thickness 
    Mark
    Thickness
    1
    11.547 to 11.555 mm (0.4546 to 0.4549 in.)
    2
    11.555 to 11.563 mm (0.4549 to 0.4552 in.)
    3
    11.564 to 11.571 mm (0.4553 to 0.4556 in.)
    4
    11.572 to 11.579 mm (0.4556 to 0.4559 in.)
    5
    11.580 to 11.587 mm (0.4559 to 0.4562 in.)
    Driven Gear Thickness 
    Mark
    Thickness
    1
    11.547 to 11.555 mm (0.4546 to 0.4549 in.)
    2
    11.555 to 11.563 mm (0.4549 to 0.4552 in.)
    3
    11.564 to 11.571 mm (0.4553 to 0.4556 in.)
    4
    11.572 to 11.579 mm (0.4556 to 0.4559 in.)
    5
    11.580 to 11.587 mm (0.4559 to 0.4562 in.)



3. INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY


C138514
  1. Using a dial indicator, measure the inside diameter of the oil pump body bushing.

    Standard inside diameter:
    43.113 to 43.138 mm (1.697 to 1.698 in.)

    Maximum inside diameter:
    43.188 mm (1.70 in.)

    If the inside diameter is more than the maximum, replace the oil pump body sub-assembly.



4. INSPECT STATOR SHAFT ASSEMBLY


C138513
  1. Using a dial indicator, measure the inside diameter of the stator shaft bushing.

    Standard inside diameter:
    22.500 to 22.526 mm (0.886 to 0.887 in.)
    Maximum inside diameter:
    22.570 mm (0.889 in.)

    If the inside diameter is more than the maximum, replace the stator shaft assembly.