Home › TRANSMISSION ยท U660F AUTOMATIC TRANSAXLE › OIL PUMP

OIL PUMP > DISASSEMBLY

for Preparation Click here



1. INSPECT FRONT OIL PUMP BODY AND GEAR SUB-ASSEMBLY


C138512
  1. Turn the drive gear with 2 screwdrivers and make sure that it rotates smoothly.

    NOTICE:
    Be careful not to damage the lip of the oil seal.



2. REMOVE STATOR SHAFT ASSEMBLY


C138275
  1. Using a T30 "TORX" wrench, remove the 16 bolts and stator shaft from the oil pump body.



3. INSPECT CLEARANCE OF FRONT OIL PUMP BODY AND GEAR SUB-ASSEMBLY


C138509
  1. Push the driven gear to one side of the oil pump body.

  1. Using a feeler gauge, measure the clearance.

    Standard clearance:
    0.08 to 0.15 mm (0.00315 to 0.00590 in.)

    Maximum clearance:
    0.15 mm (0.00590 in.)

    If the clearance is more than the maximum, replace the front oil pump body and gear sub-assembly.



    C138511
  1. Using a straightedge and feeler gauge, measure the side clearance of both gears.

    Standard side clearance:
    0.025 to 0.04 mm (0.000984 to 0.00157 in.)
    Maximum side clearance:
    0.04 mm (0.00157 in.)

    If the clearance is more than the maximum, replace the front oil pump body and gear sub-assembly.
    Drive Gear Thickness 
    Mark
    Thickness
    1
    11.547 to 11.555 mm (0.4546 to 0.4549 in.)
    2
    11.555 to 11.563 mm (0.4549 to 0.4552 in.)
    3
    11.564 to 11.571 mm (0.4553 to 0.4556 in.)
    4
    11.572 to 11.579 mm (0.4556 to 0.4559 in.)
    5
    11.580 to 11.587 mm (0.4559 to 0.4562 in.)
    Driven Gear Thickness 
    Mark
    Thickness
    1
    11.547 to 11.555 mm (0.4546 to 0.4549 in.)
    2
    11.555 to 11.563 mm (0.4549 to 0.4552 in.)
    3
    11.564 to 11.571 mm (0.4553 to 0.4556 in.)
    4
    11.572 to 11.579 mm (0.4556 to 0.4559 in.)
    5
    11.580 to 11.587 mm (0.4559 to 0.4562 in.)



4. REMOVE FRONT OIL PUMP BODY O-RING


C138278
  1. Remove the O-ring from the oil pump body.



5. REMOVE FRONT OIL PUMP DRIVE GEAR


C138276
  1. Remove the front oil pump drive gear from the oil pump body.



6. REMOVE FRONT OIL PUMP DRIVEN GEAR


C138277
  1. Remove the front oil pump driven gear from the oil pump body.



7. REMOVE FRONT OIL PUMP OIL SEAL


C138508E01
  1. Mount the oil pump between aluminum plates in a vise.

  1. Using SST, tap out the oil seal from the oil pump body.

    SST
    09308-00010