Home › TRANSMISSION ยท U660F AUTOMATIC TRANSAXLE › OIL PUMP

OIL PUMP > REASSEMBLY

for Preparation Click here



1. INSTALL FRONT OIL PUMP OIL SEAL


C188149E01
  1. Using SST and a hammer, install a new oil seal to the oil pump body.

    SST
    09350-32014   (09351-32140)

    Standard depth:
    -0.25 to 0.25 mm (-0.00984 to 0.00984 in.)

  1. Coat the lip of the oil seal with MP grease.



2. INSTALL FRONT OIL PUMP BODY O-RING


C138278
  1. Coat a new O-ring with ATF and install it to the oil pump body.

    NOTICE:
    Ensure that the O-ring is not twisted.



3. INSTALL FRONT OIL PUMP DRIVEN GEAR


C138277
  1. Coat the front oil pump driven gear with ATF and install it to the oil pump body.



4. INSTALL FRONT OIL PUMP DRIVE GEAR


C138276
  1. Coat the front oil pump drive gear with ATF, and install it to the oil pump body with the marked side facing up.



5. INSTALL STATOR SHAFT ASSEMBLY


C138275E02
  1. Align each knock pin of the stator shaft with the holes in the oil pump body and install the stator shaft to the oil pump body.

  1. Using a T30 "TORX" wrench, install the 16 bolts.

    Torque:
    9.3 N*m{ 95 kgf*cm , 82 in.*lbf }

    HINT:
    Each bolt length is indicated below.
    Bolt A: 14 mm (0.551 in.)
    Bolt B: 26 mm (1.02 in.)



6. INSPECT FRONT OIL PUMP BODY AND GEAR SUB-ASSEMBLY


C138512
  1. Turn the drive gear with 2 screwdrivers and make sure that it rotates smoothly.

    NOTICE:
    Be careful not to damage the lip of the oil seal.