Home › HEATER & AIR CONDITIONING SYSTEM › HEATER › COMBUSTION TYPE POWER HEATER SYSTEM

COMBUSTION TYPE POWER HEATER SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK HEATER ASSEMBLY

E124453E08

  1. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    A31-1 (E) - Body ground
    W-B - Body ground
    Ground for main power supply
    Always
    Below 1 Ω
    A31-2 (L) - Body ground
    G - Body ground
    Heater pump operation signal
    Engine idling
    Heater switch on
    Pulse generation
    (See waveform 1)
    A31-3 (IG) - Body ground
    Y - Body ground
    Power heater operating signal
    Ignition switch ON
    Heater switch on
    11 to 14 V
    A31-3 (IG) - Body ground
    Y - Body ground
    Power heater operating signal
    Ignition switch ON
    Heater switch off
    Below 1 V
    A31-5 (B) - Body ground
    R - Body ground
    Power source
    Always
    11 to 14 V
    A31-8 (+) - Body ground
    W - Body ground
    Engine operating signal (Generator L terminal)
    Engine idling
    (Generator operating)
    11 to 14 V



  2. E130372E03
  3. Using an oscilloscope, check waveform 1.
    Heater Pump Control Signal 
    Item
    Content
    Terminal No. (Symbol)
    A31-2 (L) - Body ground
    Tool Setting
    2 V/DIV., 20 ms/DIV.
    Condition
    Engine idling
    Heater switch on