Home › HEATER & AIR CONDITIONING SYSTEM › HEATER › COMBUSTION TYPE POWER HEATER SYSTEM

COMBUSTION TYPE POWER HEATER SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here


NOTICE:
The cause of problems (such as abnormal voltage, overheating, short circuits, component failure, etc.) can be checked by connecting the DTC tester and reading DTCs.


DTC CHECK/CLEAR
  1. Turn the ignition switch off.

  2. Disconnect the A31 heater assembly connector.

  3. Connect connector A of the DTC tester to the vehicle wire harness.

  4. Connect connector B of the DTC tester to the heater assembly connector.

  5. Start the engine.

  6. Read the DTCs.

    1. Press the DTC call button to display 3-digit DTCs.



  7. Clear the DTCs.



    1. Press both memory clear buttons together for more than 2 seconds.


      E124452E04


DESCRIPTION OF DTC TESTER

HINT:
The DTC tester is able to store up to 5 DTCs in memory. If it is full, new data is written and the oldest DTCs are cleared.

Item
Description
AF
Current malfunction (Blinking in the event of a current malfunction)
DIAG
DTC (Example: 064 flame sensor malfunction)
DTC Call Button
Reads the DTCs
Memory Clear Button
Clears the DTC memory
DTC Memory Call Button (>)
Cycles through the DTC memory (F1 - F5)
DTC Memory Call Button (<)
Cycles through the DTC memory (F5 - F1)