COMBUSTION TYPE POWER HEATER SYSTEM > Power Heater Switch Circuit |

| 1.INSPECT HEATER SWITCH ASSEMBLY (POWER HEATER SWITCH) |
![]() |
Remove the heater switch assembly (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 4 (IG) - 1 (IN) | Heater switch on | Below 1 Ω |
| 4 (IG) - 1 (IN) | Heater switch off | 10 kΩ or higher |
Apply battery voltage to the power heater switch and check that the operation indicator comes on.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 1 (IN) Battery negative (-) → Terminal 5 (E) | Indicator comes on |
Apply battery voltage to the power heater switch and check that the illumination comes on.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 3 (ILL+) Battery negative (-) → Terminal 2 (ILL-) | Illumination comes on |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (HEATER SWITCH ASSEMBLY - BODY GROUND) |
![]() |
Disconnect the E1 switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E1-5 (E) - Body ground | Always | Below 1 Ω |
| *1 | Front view of wire harness connector (Heater Switch Assembly [Power Heater Switch]) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (HEATER ASSEMBLY - BATTERY) |
![]() |
Disconnect the A31 heater connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A31-3 (IG) - Body ground | Ignition switch ON Heater switch on | 11 to 14 V |
| A31-3 (IG) - Body ground | Ignition switch ON Heater switch off | Below 1 V |
| *1 | Front view of wire harness connector (to Heater Assembly) |
|
| ||||
| OK | ||
| ||