Home › TRANSMISSION ยท U660F AUTOMATIC TRANSAXLE › DIFFERENTIAL CASE

DIFFERENTIAL CASE > INSPECTION

for Preparation Click here



1. INSPECT DIFFERENTIAL SIDE GEAR BACKLASH


C083562E01
  1. Hold the differential case in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. Place a dial indicator at a right angle to one of the side gear teeth.

  1. Hold the pinion gear in the differential case and measure the backlash of the side gear.

    Standard backlash:
    0 to 0.15 mm (0 to 0.00591 in.)

    Thrust Washer Thickness:
    Thickness
    Thickness
    1.50 mm (0.0591 in.)
    1.75 mm (0.0689 in.)
    1.55 mm (0.0610 in.)
    1.80 mm (0.0709 in.)
    1.60 mm (0.0630 in.)
    1.85 mm (0.0728 in.)
    1.65 mm (0.0650 in.)
    1.90 mm (0.0748 in.)
    1.70 mm (0.0669 in.)
    -

    If the backlash is not within the specified range, replace both side gear thrust washers with side gear thrust washers of a different thickness.