Home › DRIVE LINE › DIFFERENTIAL › ACTIVE TORQUE CONTROL 4WD SYSTEM

ACTIVE TORQUE CONTROL 4WD SYSTEM > CALIBRATION

for Preparation Click here



DESCRIPTION
  1. When the 4WD control ECU is replaced with a normal one from another vehicle or the yaw rate sensor is replaced, perform calibration.

  2. Follow the chart to perform calibration.

    Replacing Parts
    Necessary operation
    4WD Control ECU (When replaced with a normal one from another vehicle)
    1. Clear zero point calibration data
    2. Yaw rate and deceleration sensor zero point calibration
    Yaw Rate Sensor

    HINT:
    1. When the 4WD control ECU is replaced with a new one, calibration is unnecessary.
    2. Calibrate the 4WD control ECU by performing calibration of the vehicle stability control system.


PERFORM CALIBRATION
  1. Calibrate the 4WD control ECU by performing the vehicle stability control system calibration.

    HINT:
    To perform the vehicle stability control system calibration, refer to PERFORM ZERO POINT CALIBRATION OF YAW RATE AND DECELERATION SENSOR FOR 4WD VEHICLES AND 2WD VEHICLES (When not Using Intelligent Tester) (Click here).