Home › ENGINE ยท 2AD-FTV › INTAKE › TURBOCHARGER

TURBOCHARGER > INSPECTION

for Preparation Click here



1. INSPECT AXIAL PLAY OF TURBINE SHAFT


A201789
  1. Insert the needle of a dial indicator into the exhaust side of the turbine shaft.

  1. Move the turbine shaft in the axial direction and measure the axial play of the turbine shaft using the dial indicator.

    Maximum axial play:
    0.080 mm (0.00315 in.)

    If the axial play is more than the maximum, replace the turbocharger sub-assembly.



2. INSPECT RADIAL PLAY OF TURBINE SHAFT


A201791
  1. Insert the needle of a dial indicator into the oil outlet hole, and set it against the center of the turbine shaft.

  1. Move the turbine shaft in the radial direction and measure the radial play of the turbine shaft using the dial indicator.

    Maximum radial play:
    0.110 mm (0.00433 in.)

    If the radial play is more than the maximum, replace the turbocharger sub-assembly.



3. INSPECT ACTUATOR AND NOZZLE VANE OPERATION


A201793
  1. Connect a vacuum pump to the actuator.

  1. When applying a vacuum in the actuator, check that the rod moves toward the actuator and that the nozzle vane moves.

    HINT:
    Visually check the movement by looking inside the turbocharger from the area where the turbocharger connects to the exhaust manifold.
    If the rod does not move, replace the turbocharger sub-assembly.