Home › ENGINE ยท 2AD-FHV › EMISSION CONTROL › EGR VALVE

EGR VALVE > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 6 bolts, 10 clips and engine under cover.



2. DRAIN ENGINE COOLANT
  1. Loosen the radiator drain cock plug.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Remove the radiator reservoir cap.

    CAUTION:
    Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.



  1. Loosen the cylinder block drain cock plug.

    HINT:
    The plug is on the backside of the generator on the EGR cooler side.



    A208259E01


    Text in Illustration 
    *1
    Radiator Reservoir Cap
    *2
    Radiator Reservoir
    *3
    Cylinder Block Drain Cock
    *4
    Radiator Drain Cock Plug



3. REMOVE NO. 1 ENGINE COVER


    A203808
  1. Detach the 4 clips and remove the engine cover.

    NOTICE:
    Attempting to detach both the front and rear clips at the same time may cause the cover to break.



4. REMOVE RADIATOR SUPPORT OPENING COVER


B209240
  1. Remove the 9 clips and radiator support opening cover.



5. REMOVE EGR VALVE BRACKET


    A206310
  1. Disconnect the 2 connectors and detach the 2 wire harness clamps.



    A206475
  1. Remove the 3 bolts and EGR valve bracket.



6. DISCONNECT NO. 7 WATER BY-PASS HOSE


A201866


7. DISCONNECT NO. 8 WATER BY-PASS HOSE


A201867


8. REMOVE NO. 2 EGR PIPE SUB-ASSEMBLY


    A197538
  1. Disconnect the electric EGR control valve connector.



    A197541E01
  1. Remove the 3 bolts, 2 nuts, No. 2 EGR pipe and 2 gaskets.
    Text in Illustration 
    *1
    Nut



9. REMOVE ELECTRIC EGR CONTROL VALVE ASSEMBLY


    A197543
  1. Remove the electric EGR control valve and gasket.