Home › ENGINE ยท 2AD-FHV › EMISSION CONTROL › EGR COOLER

EGR COOLER > INSTALLATION

for Preparation Click here



1. INSTALL NO. 2 EGR VALVE ASSEMBLY


    A206449E01
  1. Install a new gasket and the No. 2 EGR valve.



2. INSTALL NO. 1 EGR PIPE SUB-ASSEMBLY
  1. Install a new gasket to the No. 2 EGR valve.



    A206448E01
  1. Temporarily install the No. 1 EGR pipe with the 2 bolts and 2 nuts.
    Text in Illustration 
    *1
    Nut



3. INSTALL EGR COOLER WITH PIPE ASSEMBLY


    A206447E01
  1. Install a new O-ring to the EGR cooler with pipe.

  1. Install a new gasket to the EGR cooler and a new gasket to the No. 1 EGR pipe.



  1. Temporarily install the EGR cooler with pipe with the 6 bolts and 2 nuts labeled A, B and C.


    A206450E01


    Text in Illustration 
    *1
    Nut
    -
    -

    Standard Bolt:

    Item
    Length
    Bolt A
    16 mm (0.630 in.)
    Bolt B
    16 mm (0.630 in.)
    Bolt C
    25 mm (0.984 in.)

  1. Tighten the 2 bolts and 2 nuts labeled A shown in the illustration.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Tighten the 2 bolts labeled B shown in the illustration.

    Torque:
    16 N*m{ 163 kgf*cm , 12 ft.*lbf }

  1. Tighten the 2 bolts labeled C shown in the illustration.

    Torque:
    24 N*m{ 245 kgf*cm , 18 ft.*lbf }

  1. Tighten the 2 bolts and 2 nuts labeled D shown in the illustration.

    Torque:
    21 N*m{ 214 kgf*cm , 15 ft.*lbf }



    A197511
  1. Connect the vacuum hose.



4. INSTALL NO. 5 WATER BY-PASS HOSE (for Manual Transaxle)


A197509


5. INSTALL NO. 1 TURBO WATER HOSE (for Manual Transaxle)


A197508


6. INSTALL NO. 2 WATER BY-PASS HOSE (for Automatic Transaxle)


A197507


7. INSTALL EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY
  1. Install the exhaust manifold converter sub-assembly (Click here).