Home › ENGINE · 2AD-FTV › INTAKE › VACUUM REGULATING VALVE

VACUUM REGULATING VALVE > INSPECTION

for Preparation Click here



1. INSPECT VACUUM REGULATING VALVE ASSEMBLY


    A201829E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    11.1 to 12.5 Ω

    Text in Illustration 
    *1
    Component without harness connected
    (Vacuum Regulating Valve)
    If the result is not as specified, replace the vacuum regulating valve assembly.



  1. Inspect vacuum regulating valve operation.



      A201833E01
    1. Check that air flows from port E to G.



    2. A201834E01
    3. Apply battery voltage to the terminals as shown in the illustration.

    4. Check that air flows from port E to the filter.
      If the result is not as specified, replace the vacuum regulating valve assembly.