Home › ENGINE · 2AD-FHV › EMISSION CONTROL › EXHAUST FUEL ADDITION INJECTOR

EXHAUST FUEL ADDITION INJECTOR > INSPECTION

for Preparation Click here



1. INSPECT EXHAUST FUEL ADDITION INJECTOR ASSEMBLY


    A201818E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    7.1 to 7.9 Ω

    Text in Illustration 
    *1
    Component without harness connected
    (Exhaust Fuel Addition Injector)

    HINT:
    The temperature indicated in "Condition" is the temperature of the exhaust fuel addition injector assembly.

    If the result is not as specified, replace the exhaust fuel addition injector assembly.