EXHAUST FUEL ADDITION INJECTOR > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE NO. 1 ENGINE COVER |
![]() |
Detach the 4 clips and remove the engine cover.
| 3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY |
![]() |
Detach the clamp and disconnect the mass air flow meter connector.
Disconnect the PCV hose.
Disconnect the air cleaner hose.
Detach the 3 clips and remove the air cleaner cap.
| 4. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY |
| 5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY |
![]() |
Detach the clamp.
Remove the 3 bolts and air cleaner case.
| 6. REMOVE FUEL HOSE PROTECTOR |
![]() |
Disconnect the connector.
![]() |
Remove the bolt and fuel hose protector.
| 7. REMOVE FUEL TUBE SUB-ASSEMBLY |
![]() |
Disconnect the exhaust fuel addition injector connector.
![]() |
Turn the retainer as shown in the illustration.
![]() |
Disconnect the fuel tube from the exhaust fuel addition injector.
![]() |
Remove the check valve and gasket.
| *1 | Check Valve |
Remove the union bolt, gasket and fuel tube.
| 8. REMOVE EXHAUST FUEL ADDITION INJECTOR ASSEMBLY |
![]() |
Remove the bolt, washer, nozzle holder clamp, exhaust fuel addition injector and gasket.
| *1 | Washer |
| *2 | Nozzle Holder Clamp |
| 9. REMOVE FUEL INJECTOR SEAL |
![]() |
Remove the fuel injector seal from the exhaust fuel addition injector.