Home › ENGINE ยท 2AD-FTV › EMISSION CONTROL › EXHAUST FUEL ADDITION INJECTOR (for DPF)

EXHAUST FUEL ADDITION INJECTOR (for DPF) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
w/ Navigation System (for HDD):
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE NO. 1 ENGINE COVER


    A203808
  1. Detach the 4 clips and remove the engine cover.

    NOTICE:
    Attempting to disengage both front and rear clips at the same time may cause the cover to break.



3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    A208830
  1. Detach the clamp and disconnect the mass air flow meter connector.

  1. Disconnect the PCV hose.

  1. Disconnect the air cleaner hose.

  1. Detach the 3 clips and remove the air cleaner cap.



4. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY


5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    A208831
  1. Detach the clamp.

  1. Remove the 3 bolts and air cleaner case.



6. REMOVE FUEL HOSE PROTECTOR


    A206325
  1. Disconnect the connector.



    A197570
  1. Remove the bolt and fuel hose protector.



7. REMOVE FUEL TUBE SUB-ASSEMBLY


    A203047
  1. Disconnect the exhaust fuel addition injector connector.



    A203048
  1. Turn the retainer as shown in the illustration.



    A203049
  1. Disconnect the fuel tube from the exhaust fuel addition injector.



    A203050E02
  1. Remove the check valve and gasket.
    Text in Illustration 
    *1
    Check Valve

  1. Remove the union bolt, gasket and fuel tube.



8. REMOVE EXHAUST FUEL ADDITION INJECTOR ASSEMBLY


    A201783E01
  1. Remove the bolt, washer, nozzle holder clamp, exhaust fuel addition injector and gasket.
    Text in Illustration 
    *1
    Washer
    *2
    Nozzle Holder Clamp



9. REMOVE FUEL INJECTOR SEAL


    A206481
  1. Remove the fuel injector seal from the exhaust fuel addition injector.