Home › ENGINE ยท 2AD-FHV › LUBRICATION › OIL LEVEL SENSOR

OIL LEVEL SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL ENGINE OIL LEVEL SENSOR


    A213268
  1. Install the sensor with the 4 bolts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }

  1. Connect the sensor connector.



2. ADD ENGINE OIL
  1. Add new engine oil.

    Standard Oil Grade:

    Oil Grade
    Oil Viscosity (SAE)
    ACEA C2
    - 0W-30
    - 5W-30


    Standard Capacity:

    Item
    Specified Condition
    Drain and refill without oil filter change
    5.5 liters (5.8 US qts, 4.8 Imp. qts)
    Drain and refill with oil filter change
    5.9 liters (6.2 US qts, 5.2 Imp. qts)
    Dry fill
    6.7 liters (7.1 US qts, 5.9 Imp. qts)



3. INSPECT FOR OIL LEAK
  1. Warm up the engine and check for an engine oil leak.



4. INSPECT ENGINE OIL LEVEL
  1. Warm up the engine, stop the engine and wait 5 minutes. The engine oil level should be between the dipstick low level mark and full level mark.
    If low, check for leakage and add oil up to the full level mark.

    NOTICE:
    Do not fill engine oil above the full level mark.



5. INSTALL NO. 1 ENGINE UNDER COVER
  1. Install the engine under cover with the 6 bolts and 10 clips.