Home › ENGINE ยท 2AD-FTV › LUBRICATION › OIL LEVEL SENSOR

OIL LEVEL SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL ENGINE OIL LEVEL SENSOR


    A213268
  1. Install the sensor with the 4 bolts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }

  1. Connect the sensor connector.



2. ADD ENGINE OIL
  1. Add new engine oil.

    Standard Oil Grade:

    Item
    Oil Grade
    Oil Viscosity (SAE)
    for CCo:
    Diesel fuel that contains between 50 ppm and 500 ppm of sulfur
    ACEA B1, API CF-4 or CF
    (You may also use API CE or CD)
    - 5W-30
    - 10W-30
    - 15W-40
    - 20W-50
    for CCo:
    Diesel fuel that contains 50 ppm or less of sulfur
    ACEA C2, B1, API CF-4 or CF
    (You may also use API CE or CD)
    - 0W-30
    - 5W-30
    - 10W-30
    - 15W-40
    - 20W-50
    for DPF
    ACEA C2
    - 0W-30
    - 5W-30


    Standard Capacity:

    Item
    Specified Condition
    Drain and refill without oil filter change
    5.5 liters (5.8 US qts, 4.8 Imp. qts)
    Drain and refill with oil filter change
    5.9 liters (6.2 US qts, 5.2 Imp. qts)
    Dry fill
    6.7 liters (7.1 US qts, 5.9 Imp. qts)



3. INSPECT FOR OIL LEAK
  1. Warm up the engine and check for an engine oil leak.



4. INSPECT ENGINE OIL LEVEL
  1. Warm up the engine, stop the engine and wait 5 minutes. The engine oil level should be between the dipstick low level mark and full level mark.
    If low, check for leakage and add oil up to the full level mark.

    NOTICE:
    Do not fill engine oil above the full level mark.



5. INSTALL NO. 1 ENGINE UNDER COVER


    A203808
  1. Attach the 4 clips to install the engine cover.