OIL LEVEL SENSOR > REMOVAL |
| 1. REMOVE NO. 1 ENGINE UNDER COVER |
Remove the 6 bolts, 10 clips and engine under cover.
| 2. DRAIN ENGINE OIL |
Remove the oil filler cap.
Remove the clip and open the oil pan drain service cover.
Remove the oil pan drain plug and gasket, and then drain the engine oil into a container.
Install a new gasket and the oil pan drain plug.
Close the oil pan drain service cover and install the clip
| 3. REMOVE ENGINE OIL LEVEL SENSOR |
![]() |
Disconnect the sensor connector.
Remove the 4 bolts and sensor.