Home › ENGINE ยท 2AD-FTV › LUBRICATION › OIL LEVEL SENSOR

OIL LEVEL SENSOR > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE UNDER COVER


    A203808
  1. Detach the 4 clips and remove the engine cover.

    NOTICE:
    Attempting to disengage both front and rear clips at the same time may cause the cover to break.



2. DRAIN ENGINE OIL
  1. Remove the oil filler cap.

  1. Remove the clip and open the oil pan drain service cover.

  1. Remove the oil pan drain plug and gasket, and then drain the engine oil into a container.

  1. Install a new gasket and the oil pan drain plug.

    Torque:
    38 N*m{ 387 kgf*cm , 28 ft.*lbf }

  1. Close the oil pan drain service cover and install the clip



3. REMOVE ENGINE OIL LEVEL SENSOR


    A213268
  1. Disconnect the sensor connector.

  1. Remove the 4 bolts and sensor.