OIL PRESSURE SWITCH > REMOVAL |
| 1. DRAIN ENGINE OIL |
Remove the oil filler cap.
Remove the clip and open the oil pan drain service cover.
Remove the oil pan drain plug and gasket, and then drain the engine oil into a container.
Install a new gasket and the oil pan drain plug.
Close the oil pan drain service cover and install the clip
| 2. REMOVE NO. 1 ENGINE COVER |
![]() |
Detach the 4 clips and remove the engine cover.
| 3. REMOVE RADIATOR SUPPORT OPENING COVER |
![]() |
Remove the 9 clips and radiator support opening cover.
| 4. REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY |
Disconnect the engine oil pressure switch connector.
![]() |
Using a 24 mm deep socket wrench, remove the engine oil pressure switch.