Home › ENGINE ยท 2AD-FTV › LUBRICATION › OIL PRESSURE SWITCH

OIL PRESSURE SWITCH > REMOVAL

for Preparation Click here



1. DRAIN ENGINE OIL
  1. Remove the oil filler cap.

  1. Remove the clip and open the oil pan drain service cover.

  1. Remove the oil pan drain plug and gasket, and then drain the engine oil into a container.

  1. Install a new gasket and the oil pan drain plug.

    Torque:
    38 N*m{ 387 kgf*cm , 28 ft.*lbf }

  1. Close the oil pan drain service cover and install the clip



2. REMOVE NO. 1 ENGINE COVER


    A203808
  1. Detach the 4 clips and remove the engine cover.

    NOTICE:
    Attempting to disengage both front and rear clips at the same time may cause the cover to break.



3. REMOVE RADIATOR SUPPORT OPENING COVER


B209240
  1. Remove the 9 clips and radiator support opening cover.



4. REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY
  1. Disconnect the engine oil pressure switch connector.



    A203809
  1. Using a 24 mm deep socket wrench, remove the engine oil pressure switch.