Home › ENGINE · 2AD-FHV › ENGINE CONTROL SYSTEM › IGNITION RELAY NO. 1

IGNITION RELAY NO. 1 > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT IG1 RELAY


A111813E12
  1. Remove the IG1 relay from the instrument panel junction block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage not applied to terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Battery voltage applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the IG1 relay.

  1. Install the IG1 relay to the instrument panel junction block.