Home › ENGINE · 2AD-FTV › ENGINE CONTROL SYSTEM › IGNITION RELAY NO. 2

IGNITION RELAY NO. 2 > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT IG2 RELAY


B060778E14
  1. Remove the IG2 relay from the engine room No. 1 relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage not applied to terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Battery voltage applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the IG2 relay.

  1. Install the IG2 relay to the engine room No. 1 relay block.