Home › BODY › EXTERIOR › REAR BUMPER (for Long Body)

REAR BUMPER (for Long Body) > REASSEMBLY

for Preparation Click here



1. INSTALL REAR BUMPER SIDE MOULDING SUB-ASSEMBLY LH (w/ Outside Moulding)


B208508
  1. Attach the 5 clips to install the side moulding.

  1. Install the screw.



2. REMOVE REAR BUMPER SIDE MOULDING SUB-ASSEMBLY RH (w/ Outside Moulding)

HINT:
Use the same procedure described for the LH side.



3. REMOVE REFLEX REFLECTOR ASSEMBLY LH


B208484
  1. Install the reflex reflector with the screw.



4. REMOVE REFLEX REFLECTOR ASSEMBLY RH

HINT:
Use the same procedure described for the LH side.



5. REMOVE LICENSE PLATE LIGHT ASSEMBLY (w/ License Plate Light)


B135719
  1. Install the light as shown in the illustration.

  1. Connect the connector.



6. REMOVE REAR CENTER BUMPER SUB-ASSEMBLY (w/ License Plate Light)


B208487
  1. Attach the 3 guides and 7 clips to install the rear center bumper.