Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM (w/ Navigation System)

REAR VIEW MONITOR SYSTEM (w/ Navigation System) > Back-up Light Circuit

for Preparation Click here


DESCRIPTION

The navigation receiver assembly receives signal from back-up light switch assembly.

WIRING DIAGRAM


B138818E16


INSPECTION PROCEDURE

1.CHECK NAVIGATION SYSTEM TYPE
  1. Check navigation system type.
    Result 
    Result
    Proceed to
    for HDD Navigation System
    A
    for DVD Navigation System
    B



B
Go to step 3
A


2.CHECK VEHICLE SIGNAL
E178235E02
  1. Enter the "Failure Check/Setting" mode and select "Vehicle Signal" (Click here).

  1. Check that the display changes between ON and OFF according to the shift lever operation.

    OK:
    Shift lever Position
    Display
    R
    ON
    Except R
    OFF

    HINT:
    This display is updated once per second. As a result, it is normal for the display to lag behind the actual change in the switch.



NG
Go to step 4
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

3.CHECK VEHICLE SIGNAL
E119736
  1. Enter the "Display Check" mode (Vehicle Signal Check Mode) (Click here).

  1. Check that the display changes between ON and OFF according to the shift lever operation (P and R).

    OK:
    Shift lever Position
    Display
    R
    ON
    Except R
    OFF

    HINT:
    This display is updated once per second. As a result, it is normal for the display to lag behind the actual change in the switch.



NG
Go to step 4
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

4.CHECK NAVIGATION RECEIVER ASSEMBLY
E180647E01
  1. Disconnect the E57 navigation receiver assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    E57-5 (REV) - Body ground
    Ignition switch ON, shift lever in R
    11 to 14 V
    E57-5 (REV) - Body ground
    Ignition switch ON, shift lever not in R
    Below 1 V

    Result 
    Result
    Proceed to
    OK (for HDD Navigation System)
    A
    OK (DVD Navigation System)
    B
    NG
    C



B
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)

C
Go to step 5
A

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)  

5.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - BACK-UP LIGHT SWITCH ASSEMBLY)
E180649E01
  1. Disconnect the E57 navigation receiver assembly connector.

  1. Disconnect the B25 back-up light switch assembly connector.

  1. Measure the resistance the according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E57-5 (REV) - B25-1
    Always
    Below 1 Ω
    E57-5 (REV) - Body ground
    Always
    10 kΩ or higher

    Result 
    Result
    Proceed to
    OK (for EA64F)
    A
    OK (for EA64)
    B
    NG
    C



B
REPLACE BACK-UP LIGHT SWITCH ASSEMBLY (Click here)

C
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

REPLACE BACK-UP LIGHT SWITCH ASSEMBLY (Click here)