Home › ENGINE · 2AD-FTV › FUEL › FUEL INJECTOR

FUEL INJECTOR > INSPECTION

for Preparation Click here



1. INSPECT INJECTOR ASSEMBLY


    A204352E04
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    0.9 to 1.1 MΩ

    Text in Illustration 
    *1
    Component without harness connected
    (Injector)

    HINT:
    The temperature indicated in "Condition" refers to the temperature of the injector assembly.

    If the result is not as specified, replace the injector assembly.