Home › TRANSMISSION · U660F AUTOMATIC TRANSAXLE › SHIFT PADDLE SWITCH

SHIFT PADDLE SWITCH > INSPECTION

for Preparation Click here



1. INSPECT TRANSMISSION SHIFT SWITCH ASSEMBLY (LH (-) AND RH (+))


C202154E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for LH 
    Tester Connection
    Switch Condition
    Specified Condition
    SDN - ECC
    "-" shift paddle operated and held (down-shift)
    Below 2.5 Ω
    SDN - ECC
    "-" shift paddle not operated (down-shift)
    1 MΩ or higher
    for RH 
    Tester Connection
    Switch Condition
    Specified Condition
    SUP - ECC
    "+" shift paddle operated and held (up-shift)
    Below 2.5 Ω
    SUP - ECC
    "+" shift paddle not operated (up-shift)
    1 MΩ or higher

    Text in Illustration 
    *1
    Component without harness connected
    (Transmission Shift Switch Assembly)
    *2
    for LH
    *3
    for RH
    If the result is not as specified, replace the transmission shift switch assembly.