Home › SERVICE SPECIFICATIONS › SERVICE SPECIFICATIONS › 2AD-FTV CHARGING

2AD-FTV CHARGING > TORQUE SPECIFICATIONS



Part Tightened
N*m
kgf*cm
ft.*lbf
Generator assembly x Engine assembly
25
255
18
for DPF:
Generator assembly x Wire harness clamp bracket
13
127
9
Terminal B x Generator assembly
9.8
100
87 in.*lbf
Wire harness bracket x Generator assembly
7.7
78
68 in.*lbf
Generator pulley x Generator rotor assembly
88 (111)
897 (1127)
65 (82)
Generator rear end cover x Generator coil assembly
4.6
47
41 in.*lbf
Generator brush holder assembly x Generator coil assembly
1.8
18
16 in.*lbf
Generator coil assembly x Generator drive end frame assembly
5.9
60
52 in.*lbf
Bearing retainer x Generator drive end frame assembly
2.3
23
20 in.*lbf
Battery current sensor assembly x No. 3 engine wire x Negative battery terminal
7.6
77
76 in.*lbf
(): For use without SST