Home › TRANSMISSION ยท U660F AUTOMATIC TRANSAXLE › ATF TEMPERATURE SENSOR

ATF TEMPERATURE SENSOR > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 6 bolts, 10 clips and engine under cover.



2. REMOVE REAR ENGINE UNDER COVER LH
  1. Remove the 2 clips and under cover.



3. DRAIN AUTOMATIC TRANSAXLE FLUID
  1. Remove the refill plug and gasket from the automatic transaxle.



    C205876
  1. Using a 6 mm socket hexagon wrench, remove the overflow plug and gasket from the automatic transaxle.



    C162883E04
  1. Using a 6 mm socket hexagon wrench, remove the No. 1 transmission oil filler tube from the automatic transaxle and drain the automatic transaxle fluid.

  1. Using a 6 mm socket hexagon wrench, install the No. 1 transmission oil filler tube to the automatic transaxle.

    Torque:
    1.7 N*m{ 17 kgf*cm , 15 in.*lbf }

    Text in Illustration 
    *1
    No. 1 Transmission Oil Filler Tube
    *2
    Hexagon Socket Wrench
    *3
    Overflow Plug Hole

  1. Using a 6 mm socket hexagon wrench, install a new gasket and the overflow plug to the automatic transaxle.

    Torque:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }

  1. Temporarily install the gasket and the refill plug to the automatic transaxle.



4. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT LH


C207602
  1. Remove the 4 bolts and front suspension member reinforcement.



5. REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY


C134962
  1. Remove the 18 bolts and oil pan from the transaxle.

    NOTICE:
    Some fluid will remain in the oil pan. Remove all the pan bolts, and carefully remove the oil pan sub-assembly.

  1. Remove the gasket from the oil pan.



    C134963E05
  1. Remove the 2 magnets from the oil pan.
    Text in Illustration 
    *1
    Magnet



    AT00103E01
  1. Examine the particles in the oil pan.

    1. Use the removed magnets to collect any steel chips. Look carefully at the chips and particles in the pan and on the magnet to anticipate what type of wear you will find in the transaxle.
      Steel (magnetic): bearing, gear and plate wear
      Brass (non-magnetic): bush wear



6. REMOVE VALVE BODY OIL STRAINER ASSEMBLY


    C136687
  1. Remove the 2 bolts and oil strainer from the valve body.



    C136688
  1. Remove the O-ring from the oil strainer.



7. REMOVE ATF TEMPERATURE SENSOR ASSEMBLY


C139240E07
  1. Disconnect the connector.

  1. Remove the 4 bolts, clamp and ATF temperature sensor from the valve body.
    Text in Illustration 
    *1
    Clamp



    C138520
  1. Remove the O-ring from the ATF temperature sensor.