VALVE BODY ASSEMBLY > REMOVAL |
| 1. REMOVE NO. 1 ENGINE UNDER COVER |
Remove the 6 bolts, 10 clips and engine under cover.
| 2. REMOVE REAR ENGINE UNDER COVER LH |
Remove the 2 clips and under cover.
| 3. DRAIN AUTOMATIC TRANSAXLE FLUID |
Remove the refill plug and gasket from the automatic transaxle.
![]() |
Using a 6 mm socket hexagon wrench, remove the overflow plug and gasket from the automatic transaxle.
![]() |
Using a 6 mm socket hexagon wrench, remove the No. 1 transmission oil filler tube from the automatic transaxle and drain the automatic transaxle fluid.
Using a 6 mm socket hexagon wrench, install the No. 1 transmission oil filler tube to the automatic transaxle.
| *1 | No. 1 Transmission Oil Filler Tube |
| *2 | Hexagon Socket Wrench |
| *3 | Overflow Plug Hole |
Using a 6 mm socket hexagon wrench, install a new gasket and the overflow plug to the automatic transaxle.
Temporarily install the gasket and the refill plug to the automatic transaxle.
| 4. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT LH |
![]() |
Remove the 4 bolts and front suspension member reinforcement.
| 5. REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY |
![]() |
Remove the 18 bolts and oil pan from the transaxle.
Remove the gasket from the oil pan.
![]() |
Remove the 2 magnets from the oil pan.
| *1 | Magnet |
![]() |
Examine the particles in the oil pan.
Use the removed magnets to collect any steel chips. Look carefully at the chips and particles in the pan and on the magnet to anticipate what type of wear you will find in the transaxle.
Steel (magnetic): bearing, gear and plate wear
Brass (non-magnetic): bush wear
| 6. REMOVE VALVE BODY OIL STRAINER ASSEMBLY |
![]() |
Remove the 2 bolts and oil strainer from the valve body.
![]() |
Remove the O-ring from the oil strainer.
| 7. REMOVE TRANSMISSION VALVE BODY ASSEMBLY |
![]() |
Remove the 11 bolts and valve body from the transaxle.
| 8. REMOVE MANUAL VALVE |
![]() |
Remove the manual valve from the valve body.