Home › TRANSMISSION · U660F AUTOMATIC TRANSAXLE › PARK / NEUTRAL POSITION SWITCH

PARK / NEUTRAL POSITION SWITCH > INSPECTION

for Preparation Click here



1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY


C197712E04
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1. 1 (RB) - 3 (PL)
    2. 4 (B) - 9 (L)
    Shift lever in P
    Below 1 Ω
    1 (RB) - 2 (RL)
    Shift lever in R
    Below 1 Ω
    1. 1 (RB) - 8 (NL)
    2. 4 (B) - 9 (L)
    Shift lever in N
    Below 1 Ω
    1 (RB) - 7 (DL)
    Shift lever in D, M, "+" or "-"
    Below 1 Ω
    1. 1 (RB) - 3 (PL)
    2. 4 (B) - 9 (L)
    Shift lever not in P
    10 kΩ or higher
    1 (RB) - 2 (RL)
    Shift lever not in R
    10 kΩ or higher
    1. 1 (RB) - 8 (NL)
    2. 4 (B) - 9 (L)
    Shift lever not in N
    10 kΩ or higher
    1 (RB) - 7 (DL)
    Shift lever not in D, M, "+" or "-"
    10 kΩ or higher

    Text in Illustration 
    *1
    Component without harness connected
    (Park/Neutral Position Switch Assembly)
    If the result is not as specified, replace the park/ neutral position switch.