Home › TRANSMISSION ยท U660F AUTOMATIC TRANSAXLE › PARK / NEUTRAL POSITION SWITCH

PARK / NEUTRAL POSITION SWITCH > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE COVER


    A203808
  1. Detach the 4 clips and remove the engine cover.

    NOTICE:
    Attempting to detach both the front and rear clips at the same time may cause the cover to break.



2. REMOVE AIR CLEANER CAP AND HOSE


    A208830
  1. Detach the clamp and disconnect the mass air flow meter connector.

  1. Disconnect the PCV hose.

  1. Disconnect the air cleaner hose.

  1. Detach the 3 clips and remove the air cleaner cap.



3. REMOVE AIR CLEANER CASE


    A208831
  1. Detach the clamp.

  1. Remove the 3 bolts and air cleaner case.



4. DISCONNECT FUEL FILTER ASSEMBLY


C209708
  1. Disconnect the level warning switch connector and detach the connector clamp.

  1. Remove the bolt, and slide the fuel filter upward to disconnect it from the air cleaner bracket.



5. REMOVE AIR CLEANER BRACKET


A208834
  1. Remove the 2 nuts and air cleaner support.



    C209709
  1. Disconnect the glow relay.



    A208835
  1. Detach the 3 wire harness clamps.

  1. Detach the 2 fuel hoses from the bracket.

  1. Remove the 3 bolts and bracket.



6. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


C205890
  1. Move the shift lever to N.

  1. Remove the nut and disconnect the control cable from the control shaft lever.



7. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY
  1. Disconnect the park/neutral position switch connector.



    C136685
  1. Remove the nut, washer and control shaft lever from the control shaft.



    C135732
  1. Remove the 2 bolts and pull out the park/neutral position switch to remove it from the control shaft.