Home › TRANSMISSION ยท U660F AUTOMATIC TRANSAXLE › TCM

TCM > REMOVAL

for Preparation Click here



1. REMOVE RADIATOR SUPPORT OPENING COVER


B209240
  1. Remove the 9 clips and radiator support opening cover.



2. REMOVE REAR ENGINE UNDER COVER LH
  1. Remove the 2 clips and under cover.



3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
w/ Navigation System for HDD:
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



4. REMOVE BATTERY
  1. Disconnect the cable from the positive (+) battery terminal.

  1. Detach the 2 wire harness clamps.

  1. Remove the bolt and loosen the nut.

  1. Remove the battery clamp.

  1. Remove the battery.

  1. Remove the battery tray.



5. REMOVE FRONT BATTERY BRACKET


    A194735
  1. Detach the 2 wire harness clamps.

  1. Remove the 4 bolts and front battery bracket.



6. REMOVE BATTERY BRACKET REINFORCEMENT


    A194736
  1. Remove the 2 bolts and battery bracket reinforcement.



7. REMOVE TCM


C133604E01
  1. Detach the claw, turn the lock lever and disconnect the TCM connector.



    C206488
  1. Remove the 2 bolts and pull up the TCM from the transaxle to remove it.